Welcome to the NEW Infrared Training Forum. To view the old message board, please click here.World Class Infrared Training for Thermography Professionals


Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Transmittance in molded plastic parts
02-16-2014, 04:56 PM
Post: #7
RE: Transmittance in molded plastic parts
Great info RDanjoux. Thanks.

I was trying to make some sense of the HDPE graphs detailing the absorption rates but unfortunately another major project at work has shown up and I've had to put this one on hold for a little while. Our PM scheduling program at work was found to vulnerable to several other depts. reporting inputs and as a result I've had to focus on completing baseline inspections on all our machines. This presents another great IR application but that's for another thread.

What effect would a filter specific to HDPE have with the A315? I've been told of an application with plastic film manufacturing where the plastic was almost invisible to the IR camera due to it's transmissivity but when a filter was used the camera could image the film. I'm asking this question because I'm not entirely sure I am grasping what a filter would be filtering out of an image to correct for transmissive materials.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Transmittance in molded plastic parts - ArikB - 02-16-2014 04:56 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)
Copyright © 1999-2012 FLIR Systems, Inc.