Welcome to the NEW Infrared Training Forum. To view the old message board, please click here.World Class Infrared Training for Thermography Professionals

Post Reply 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Far IR Transparency
12-07-2012, 02:46 PM
Post: #1
Far IR Transparency
Hi All
I realize that this is not technically a question for this site but I really need some help.
I have a Far IR heating in my study. However the surface of the unit gets very hot and I am worried my toddler daughter will touch it and burn her hand. I need a material which behaves like germanium which will allow the IR through but not heat up itself. I need a fairly thick material, some kind of plastic so I can build a frame and have a small air gap between the emitter and the panel but will not be damaged by my daughter touching it. Obviously cost is a factor here or I'd just by a new heater. The IR heater is 600mm square.
Many thanks for your assistance.

Find all posts by this user
Quote this message in a reply
12-07-2012, 03:01 PM
Post: #2
RE: Far IR Transparency
I assume your heater is using a quartz tube element? I am sorry but I cannot think of a low cost material that would work (without seriously reducing the heat provided and pose a melting or fire hazard itself).
Find all posts by this user
Quote this message in a reply
12-08-2012, 11:39 AM (This post was last modified: 12-08-2012 11:40 AM by JKEngineer.)
Post: #3
RE: Far IR Transparency
You might consider putting a cage in front of the heater. You could use an expanded metal mesh or screening or chicken wire. You might consider painting the hot side silver and the room side a flat matte color so that it does not get too hot.

Please don't consider this to be professional advice - I don't know enough about your heater to offer professional advice. In other words, take this with a grain of salt.


Jack M. Kleinfeld, P.E.
Kleinfeld Technical Services, Inc.
Infrared Thermography, Finite Element Analysis, Process Engineering

Bronx, NY 10463

866-884-6644 toll free
212-214-0919 fax and voice mail
Skype: JKEngineer

JKEngineer@aol.com or JKEngineer@KleinfeldTechnical.com
come see what we can do for you: http://www.KleinfeldTechnical.com
YouTube channel: http://www.youtube.com/KleinfeldTechnical


Jack Kleinfeld, P.E.
Kleinfeld Technical Services, Inc.
Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)
Copyright © 1999-2012 FLIR Systems, Inc.